Avery Dennison AP4.4 - Removing Transportation Lock; Transportation Lock Removal Procedure

05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
6
Removing the Transportation Lock
1. Open the printer lid.
2. Remove the cable tie holding the printhead in place [7A]. For this, use side-
cutting pliers or strong scissors.
[7] AP4.4/5.4 transportation lock (A).
AP5.4 Dispenser « Remove the connector from its transport position at the printer bottom and
connect it to the connector at the frontside of the printer.
CAUTION! - Observe the following to avoid damaging the printhead:
« Do not use a knife to cut the cable tie.
A