05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
5
AP5.4 Dispenser • Printer with mounted dispensing edge
• Housing front part, bottom side with screw [6A].
• Cutter flange cover with screws [6B].
• Deflector [6C].
Enables the AP5.4 Dispenser to be operated with internal (label material)
rewinder.
¯ It is recommended to mount the housing parts, if the printer is used as
a standard device without dispensing or rewinding function.
[6] These housing parts are shipped loose with the „AP5.4 Dispenser“.
A
B
C
To Next Page
Loading...
