05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
4
• Size 10 torx screwdriver [3G]
Tool which is used to replace the print roller and to mount a dispensing
edge.
AP5.4 with Cutter Cutter [4]
Only if you ordered the “AP5.4 peripheral with cutter”.
[4] If ordered, you will find the cutter in a special carrier in the top of the printer packaging.
You can find instructions on how to mount the cutter in the Cutter Manual .
¯ The cutter hook, a part which is required to mount the cutter, can be found
fixed to the printer bottom.
AP5.4 with Internal
Rewinder
• Printer with mounted deflector
• Housing front part, bottom side with screw [5B].
• Cutter flange cover with screws [5A].
¯ It is recommended to mount the housing parts, if the printer is used as
a standard device without rewinding function.
[5] These housing parts are shipped loose with the „AP5.4 Internal Rewinder“.
AB
To Next Page
Loading...
