05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
8
[9] AP5.4 operating parts.
A Foil unwinding roll mandrel:
Holds the new foil roll.
B Foil take-up roll mandrel:
Holds the backing paper onto which used foils are wound.
C Flange mount for additional devices:
Cutter and take-up can alternately be screwed on here. To do this, you will
need to remove the plastic cover.
D Pressure lever:
Opening the pressure lever raises the printhead. This is required when in-
serting the material or foil or to clean the printhead or printing roller.
E Material rewinder:
Labelling material roller inserted here.
F Material strain relief:
Ensures even feed of the labelling material.
G Guide plate:
Prevents the material roll from slipping sideways.
H Adapter rings:
To set the unwinder to the core diameter of the material roll.
A
B
C
D
E
F
G
H
To Next Page
Loading...
