User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 12
Please follow during media / ribbon change the upper diagrams ! This is showing
the used directions of ribbon and media ( insert ribbon – insert media)
Attention : Sometimes it is helpful to release the head and rotate the head to insert ribbon
into the printer (esp. For TTX 450 / Puma / S 45) ! As well rotating the head
means that the wires connected to the head can be to short – then please
disconnect the wires – only if the printer is switched OFF ! Do not forget to
connect again – and check if the connectors are properly mounted !
This is shown in the following chapters as well.
To Next Page
Loading...
