User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 38
Weight Approx. 25kg - without stock
Interfaces Standard: serial (RS 232) and parallel (Centronics) optional RS 485 -
in exchange against RS 232
Memory 1MB dynamic RAM
Cards 2 Slots for PCMCIA cards, 2 MB each
Certificates
TÜV GS Approved security (according to EN 60950:97)
CE conformity
The devices are marked with the CE label. The manufacturer
declares that the device conforms with the relevant European
guidelines.
EMC The EMC tests were performed according to the following norms:
EN 55022:98
EN 55024:98
EN 61000-3-2:95
EN 61000-3-3:95
EN 61000-6-2:99
Service Data
The data shown in STA3 can have a maximum value – shown in the table below. After that
value is reached the counter is set to zero and counts up again.
Number of service operations 255
Number of heads / rolls / knives 255
Head / roll run length 131 km
Cuts on knife 4.300.000.000
Total material length 430.000 km
Total foil length 430.000 km
Total number of cuts 4.300.000.000
Head moves 4.300.000.000
Head strobes 4.300.000.000
Operation time 8.800 years
To Next Page
Loading...
