User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 20
Adjustment to thickness of material
• -TDI/EXXTREME / S TDI only-
The function of separating / transport roll at the paper tray has to be adapted to different
thickness off materials in order to ensure a correct label run.
The adjustment wheel is located between paper tray and lateral material guide, a bit offset in
the base plate of the print module. It carries a red, a yellow and a green arrow.
Adjust following:
• When using thin material 2 and/or more Rotate wheel clockwise
tags are drawn in
• When using thick material, Rotate wheel anticlockwise
none tag will be drawn in
The coloured arrows may be positioned at the wheel in order to set marks for different types
of tags.
Clip
To Next Page
