User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 15
Material exchange
• Switch printer to OFFLINE mode and lift printhead by brief pressing of the
(FF)-key.
• Remove material by pressing the red lift lever and drawing the material
backward.
• -TTX 650 / LION / S 65 only-
By pressing the ON/OFFLINE and CUT key simultaneously the material will be
transported backward.
• -TDI / EXXTREME / S TDI only-
Move paper tray down by means of simultaneously the material will be
transported backwards automatically.
• Remove material off the mandrel or paper tray.
• For continuing steps see description above.
Insertion of fan folded material
• -TTX 650 / LION / S 65 only-
• Remove blade at rear side of unit.
• Set outer material guide disk according to width of material.
• Insert material with imprint side up.
• For continuing steps see description: Insertion of material.
Insertion of Thermal Transfer Ribbon
• Attach ribbon reel onto foil mandrel on the right-hand side for anticlockwise unwinding of
ribbon. Attach empty ribbon core onto mandrel on left-hand side.
• Insert ribbon end diagonally from the front under print-head holder or between knife cover
and printhead holder with open hinge drive mechanism. If foil is changed during a print job,
lift print head by short depression of the FF key.
To Next Page
Loading...
