User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 37
¯
Label stock which is thicker than 0.25 mm and/or heavier than
240 g/m
2
must be tested regarding printability. The testing must be
done with a sufficiently large number of labels. Given a poor print
result, the printhead position must possibly be changed.
P See “Service Manual TTX 67x”, topic section “Service print module”,
chapter “Adjusting the print head position”.
Ribbon specifications
Ribbon roll Roll max. outer ∅ 90mm, inner ∅ 1“ (25,4 mm)
Width 30 up to 132mm
Auto Economy Mode Starting up from > 10 mm imprint free length (on the last 32 mm of a
label only if SYSP/FMOD/SAVE is set to LEHU)
Fonts, Bar Codes
Fonts 17 Fonts inclusive OCR-A and OCR-B; 2 scaleable fonts
Character modification Margination in X/Yup to factor 8, rotation: 90,180,270 degrees
Barcodes EAN 8 and 13 with Add-On 2 and 5, UPC-A, UPC-E, Code 93,
Code 39 (Ratio 1:2, 1:2,5 and 1:3), Code ITF, Codabar, Code 128,
Code 2/5, Code 2/5 lnterleaved (Ration 1:2 and 1:3), Code 2/5 5,
Code 2/5 Matrix (Ratio 1:2, 1:2,5 and 1:3), Code MSI, Code EAN 128,
Postcode (Lead-and Identcode), UPS-Code 128
All bar codes in 16 widths, unlimited in height.
Operating Features
Operation 3 key panel with 4 digit display.
Adjustments Definition of parameters via menu or Easy Plug commands.
Test print outs of parameter adjustments, downloaded logos, font, line, and barcode
library.
Test functions Print tests with cut, Test routines to memory and sensors
Error messages Shows error messages on the display; continution of print jobs
without label loss
Connection, Device Data
Mains voltage 115/230/240 V +/- 10%, switchable
Mains frequency 50/60 Hz
Power consuption 336 VA
Current approx. 3 A at 115 V and 1,5 A at 230/240 V
Fuses 8 A at 115V, 6,3 A at 230 V and 6,3 A at 240 V
Ambient conditions Operation temperature: +5 up to +35 degree C
Storage temperature: -20 up to + 70 degree C
Humidity: 45 to 75%, non condensing
Dimensions WxHxD 840x420x380mm