Punch
Hole
Remova
l
You can remove punch holes from the output
scanned image when scanning punched document.
Note the availability of this feature varies
depending on your scanner model.
Punch holes can not be removed when:
Resolution is set lower than 150dpi
The hole is near the edge of the document
The holes are not aligned along the edge of the
document
Punch Hole Removal is available only when “Auto
Crop” is enabled. If either “Fixed to Transport”,
“EOP (End of Page) Detection”, “Automatic
Multiple”, “Relative to Documents” is selected
from the Cropping option on the Paper tab, the
Punch Hole Removal option will be disabled.
Original Output image
To Next Page
Loading...
