AVL 9180 Service Manual

51
4.1.9 Lamp Board
The rear panel and SBC board must be removed to gain access to the lamp
board. Remove one screw and washer which hold the board in place and
remove the electrical connectors to remove this board.
4.1.10 Display Board
The rear panel and SBC board must be removed to gain access to the display
board. Remove three screws and 50 degree spacers and unplug the sample
sensor cable from the front and the ribbon cable to the SBC board to remove
the display board.

AVL 9180 Specifications

General

Brand	AVL
Model	9180
Category	Measuring Instruments
Language	English