12
2.17 Headphones / front input
2.17.1 Headphones
Plug the 3.3 mm headphones plug to the headphone jack (11). The loudspeaker and preamp outputs will
mute automatically when the plug is in.
2.17.2 Front input
The 3.5 mm jack in the front panel (11) can be configured as an additional input (see 4.13). You can use it
then for easy connection of a music player.
NOTE: the front input is connected in parallel to the rear input IN5. The inputs are naturally decoupled from
each other. If you use the front input you must switch off a signal source which is eventually connected to the
rear input IN5. There is off course no risc of damage for the units. But the signals of BOTH sources will
otherwise be mixed and be audible at the same time.
2.18 Antenna connection (if optional tuner is installed)
Connect the Antenna cable to the antenna socket (15).
To Next Page
Loading...
