22
10.1.6 FM auto store (only if tuner installed)
This function is useful when storing a large quantity of stations from cable. Please note that the stations are
stored including the actual tuner setting (see 4.1 - 4.5). For cable we recommend: RDS-display = name,
scanmode = auto, 2-ch mode = stereo, bandwidth = narrow, sensitivity = local.
Once the tuner parameters are set in the desired way enter the personal setup and select "FM auto store".
Then press the button START (5). While the auto store function is in progress all stations are played audibly
for half a second. When the function is terminated the display shows for 2 seconds the number if stations
found. Then the unit comes back to normal tuner operating mode.
If desired you can now shift certain stations to different positions, change the settings and store back or
delete unwanted stations (see 3.5.2).
10.2 Reset
This function cancels certain or all settings and makes the unit return to default settings.
To perform the reset switch the unit to standby (power button (1)). Then press and hold the middle key (7)
under the display (4). While holding that key switch the unit on (power button (1)). The display now will show
the reset menu.
Select if you want to clear the station memory ("STAT"), the input names ("NAME") or reset the unit
completely ("ALL").
"CANCEL" will bring the unit back to normal operating mode without resetting any item.
To Previous Page
Loading...
Need help?
General
