15
4. Menu system
The PA3.2 / A3.2 / A5.2 offer a lot of custom specific settings in their menu system. To enter the menu just
tip on the button MENU (7). The button now changes to EXIT. A second tip on this button leads you to the
normal operating mode. When the menu system is active you can select the desired function using the
buttons ITEM (5, 6). The setting is done using the buttons VALUE (8, 9). Depending on the actual
source the menu system offers the following settings:
4.1 RDS-Display (tuner must be selected as source)
Choose if station NAME, RDS-TEXT or FREQUENCY is displayed.
4.2 Scanmode (tuner must be selected as source)
Set tuning mode between "auto" or "manual". (See also 3.5.1)
4.3 2-ch-Mode (tuner must be selected as source)
Set tuner to mono or stereo to obtain best sound.
NOTE: Depending on actual setting the threshold for auto tuning will change (sensitive in MONO, less
sensitive in STEREO).
4.4 Bandwidth (tuner must be selected as source)
Select bandwidth "narrow" / "wide" for best reception.
4.5 Sensitivity (tuner must be selected as source)
Choose between "local" (in case the tuner operates from a cable) and "distant" (if operated from antenna)
4.6 Tone control
Set tone control to "bypass" (= linear) or "active". In case the tone control is activated "TONE ON" is shown
in the display (4), otherwise "LINEAR".
You can choose if you want to change bass and treble settings simultaneously for all inputs ("global") or
especially for the actual input ("individual"). See 10.1.2
The loudness function depends on speakers and properties of the listening room and is therefore always
"global".
NOTE: In case tone control is set to "bypass" the menu will skip the bass, treble, and loudness settings (4.7 -
4.9).
Set tone control to "bypass" (= linear) or "active". In case the tone control is activated a "TONE ON" is shown
in the display (4).
4.7 Bass
Set bass level between – 5 and + 9.
4.8 Treble
Set treble level between – 7 and + 7.
To Next Page
Loading...
Need help?
General
