AVM Fritz!Box 3490 User Manual

Network Settings in the FRITZ!Box
FRITZ!Box 3490 103
Fixed IPv4 Addresses When the DHCP Server Is Enabled
If you would like to configure fixed IPv4 addresses on individual
computers connected with the FRITZ!Box even though DHCP
server is enabled, please note the following:
• The IPv4 addresses must be from the IPv4 network of the
FRITZ!Box.
• The IPv4 addresses may not come from the address
range of the DHCP server.
• Each IPv4 address can be assigned only once.
Disabling the DHCP Server
You can disable the DHCP server.
To make sure that all computers remain in the same IP net-
work when the DHCP server is disabled, you must enter the
IPv4 addresses manually in the computers’ network settings.
First disable the option “Obtain an IP address automatically”
and then enter the IP address manually in the appropriate
field.
In the case of the preset IPv4 address of the FRITZ!Box, the
following IPv4 addresses are available for assignment to the
computers:
Here too: each IPv4 address can be assigned only once.
Changing Network Settings
1. Open the FRITZ!Box user interface; see page 25.
2. Enable the advanced view.
3. Select the “Home Network / Network” menu.
4. Select the “Network Settings” page.
5. Click the “IPv4 Addresses” or “IPv6 Addresses” button,
depending on the address range you would like to
change.
192.168.178.2 – 192168178254

AVM Fritz!Box 3490 Specifications

General

Brand	AVM
Model	Fritz!Box 3490
Category	Network Router
Language	English