Obtaining an IP Address Automatically
FRITZ!Box 3490 105
The DHCPv6 server assigns the network devices their IPv6 set-
tings. These settings are used instead of the data in the router
advertisement messages. The DNS server, IPv6 prefixes or IPv6
addresses can all be assigned by DHCPv6. Define which IPv6
settings should be assigned by the DHCPv6 server.
UPnP Settings
The Universal Plug-and-Play (UPnP) service included in your
FRITZ!Box provides status information about the FRITZ!Box to
all connected computers. UPnP-compliant programs on these
computers can receive this information and use it to display
the status of the FRITZ!Box (e.g., connection status, data
transmission). UPnP service thus allows you to monitor your
FRITZ!Box from a connected computer.
Here is how to change the UPnP settings:
1. Open the FRITZ!Box user interface; see page 25.
2. Enable the advanced view.
3. Configure the UPnP settings in the “Home Network / Net-
work” menu on the “Programs” page.
14.2 Obtaining an IP Address Automatically
The FRITZ!Box has its own DHCP server, which assigns IP ad-
dresses to the connected computers. The connected comput-
ers must be configured such that they can receive their IP ad-
dresses automatically. The steps for checking and adjusting
this option differ among the operating systems. See the rele-
vant section for your operating system.
If FRITZ!Box is operated in a network, no other DHCP server
may be activated in this network.
To Next Page
Loading...
Need help?
General
