AVM Fritz!Box 3490 User Manual

LISP: FRITZ!Box as a LISP Router
FRITZ!Box 3490 83
Here is how to set up the mobile telephone connection as a
substitute upon DSL failure:
1. Insert the USB modem in the USB port on the FRITZ!Box.
2. Open the FRITZ!Box user interface; see page 25.
In the “Internet” menu, the sub-menu “Mobile Commu-
nications” is displayed.
3. Select the setting “Automatically enable the mobile con-
nection when the DSL connection is disrupted”.
4. Configure the settings for your Internet connection over
the mobile communications network. In the Help of the
FRITZ!Box user interface you can find detailed instruc-
tions.
Access to the Internet is now guaranteed, even when the DSL
connection fails.
As soon as the DSL connection is stable and available for at
least 30 minutes, the connection will be switched back to
DSL.
12.11 LISP: FRITZ!Box as a LISP Router
LISP is a routing architecture which separates information
about location and identity. There are two IP addresses: one
for the location and one for the identity.
The FRITZ!Box can be configured as a LISP router.
• This chapter address system administrators.
• It presents a short introduction to LISP.
• You receive an overview about the possibilities for using
LISP.
• This section includes instructions on how to configure
the FRITZ!Box as a LISP router.
The “Mobile Communications” menu is not available
until the UMTS/HSPA modem has been connected to the
USB port of the FRITZ!Box.

AVM Fritz!Box 3490 Specifications

General

Brand	AVM
Model	Fritz!Box 3490
Category	Network Router
Language	English