Chapter 3: Operations 27
NOTE: It is recommended that you configure the network settings for the transmitter before you configure the
network settings for the LongView IP KVM user station.
To configure network settings for the transmitter:
1. Press Enter to display the serial menu. The Appliance Selection Menu displays.
2. Press 2 to access the Transmitter Menu. If the password option is enabled, you will be
prompted for a password.
3. Type the password and press Enter. The Transmitter Main Menu will appear.
Figure 3.4: Transmitter Main Menu
NOTE: The Reset Appliance option in the Transmitter Main Menu applies only to network settings.
4. Press 1 to select the Network Configuration option and press Enter.
Figure 3.5: Network Configuration Menu
To Next Page
Loading...
