28 LongView® IP KVM Extenders Installer/User Guide
5. Press 1 to select the Transmitter Network Config option and press Enter.
Figure 3.6: Transmitter Network Configuration Menu
6. Press 1 to select the Transmitter IP Address option and press Enter.
7. Type a valid IP address and press Enter.
8. Press 2 to select the Transmitter Netmask option and press Enter.
9. Type a valid Transmitter Netmask. Press Enter to return to the Transmitter Network
Configuration Menu.
10. Press 3 to select the Transmitter Default Gateway option and press Enter.
11. Type a valid Transmitter Default Gateway and press Enter.
12. Type 0 (zero) and press Enter to exit and apply changes, or to return to the Network
Configuration Menu. If you made a mistake and do not wish to save the changes you made to
the network settings, type
C and press Enter. You will be automatically returned to the Main
Menu.
To configure network settings for the user station:
1. Press option 1 to access the Receiver Menu and press Enter. If the password option is enabled,
you will be prompted for a password.
To Next Page
Loading...
