5
Introduction
Introduction
1. Front View
1. (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Blue) Standby mode
Indicator on(Null) Power on mode
2. The functions of the buttons:
TV/AV: Press to display the input source menu.
MENU: Press to display the OSD menu,
press again to exit the menu.
CH+/-: Press to scan through channels.
VOL+/-: Press to adjust the volume.
POWER: Turn on/standby the TV set.
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
0
to the left or right side and 20
0
above or below the remote control
window.
Press TV/AV button on the TV set or on remote
control to display the input source menu, and use
CH+/- button on the TV set or
ġ
/
Ģ
button on remote
control to select the input source, press OK button on the
remote control to enter.
Note: Before you select the input source, make sure the
connections are prepared.
TV
AV
S-Video
Component
HDMI
VGA
INPUT SOURCE
LED Indicator POWER
Remote Control window
(Keep clear)
DVD
Please insert a 12cm disc
according to the silk
Play the next track or chapter
Play the previous track or chapter
Eject the disc
Play the disc playing
Pause the disc playing
Stop the disc playing
To Next Page
Loading...
