7
Flashes Steadily Solid
Status above the RJ45 (HDBaseT) Port: (Amber) This indicator shows that
theres power present between the Tx and Rx. This light blink steadily indicating
everything is OK. If you do not see this light attempt the following:
·Check the length. The maximum distances are 40m (131ft) on 4K and 70m
(230ft) on 1080P.
·Remove any coils of cable and make sure that there is not excess cabling.
·Bypass all patch panels and punch-down blocks.
·Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid,
something may be just slightly o.
·Try powering from the Receiver instead of the Transmitter
·Contact AVProEdge if these steps do not work.
To Next Page
Loading...
