AVS Ventshade User Manual

Installation Instructions
Ventshade® Deflector
Page 1 of 3
Front Driver
Side Visor
Front Passenger
Side Visor
I - Sheet Number VS04 Rev.A
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the vent visor is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Clean Towel
Car Wash Supplies
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
1
TapeTabs x10
Lower window. Use a putty knife to grasp and pull down the rubber window channel. Clean the inside of the window
channel with an alcohol pad.
Contents - 2 Piece Set
Contents - 4 Piece Set
Tools Required
Preparation Before Painting / Installation
Front Driver
Side Visor
Front Passenger
Side Visor
Rear Driver’s
Visor
Rear Passenger’s
Visor
rubber window channel
rubber window channel
Without Post With Post
Tape Tabs x18
Alcohol Pad x2
Alcohol Pad x4 Screws x2
Phillips Screwdriver
PunchPutty Knife Drill

AVS Ventshade Specifications

General

Brand	AVS
Model	Ventshade
Category	Automobile Accessories
Language	English

Summary

Important Safety Information

Preparation Before Painting / Installation

Installation Steps

Step 1: Lower Window and Clean Channel

Prepare the window channel for installation by lowering the window and cleaning the channel with an alcohol pad.

Step 2 & 3: Apply Tape Tabs

Apply tape tabs to the deflector edge, aligning them with the inner edge of the deflector flange.

Step 4 & 5: Positioning Without Vent Post

Locate and place the deflector in the upper window frame without applying tape to the front end if a vent post is present.

Step 6: Secure Deflector Flanges

Ensure deflector flanges are inside the window channel and pull outwards to secure tape adhesion.

Step 7: Replace Window Channel

Replace the rubber window channel and raise the window to fully seat it.

Rear Door Installation Preparation

For rear doors, lower the window and clean the inside of the rubber window channel with an alcohol pad.

Step 9 & 10: Secure and Screw

Pull deflector flush, drill a hole using the deflector as a guide, and insert a screw.

Step 11 & 12: Final Seating and Repetition

Replace the rubber window channel, raise the window, and repeat steps for remaining windows.

Care and Cleaning