Sunflector
®
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle to remove any debris and/or dirt from installation area.
• Dry the installation area with a clean towel.
Page 1 of 2
Installation Instructions
I - Sheet Number SF05 Rev.A
Important Safety Information
• CAUTION - Before driving, ensure that the sun shield is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Contents
NOTE: Actual product may vary from illustration.
Alcohol Pad x2
Tools Required
Car Wash Supplies
Sun shield
Clean Towel
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
1 2
Peel back 2” (5cm) of tape liner from each end of sun
shield. Fold ends of the tape liner down so they will be
free for later pulling.
free end
free end
Clean the outer perimeter of the rear widow
glass and the sliding window frame with an
alcohol pad.
To Next Page
Need help?
General
