CONNECTION
8
To solve this, use our brand’s IP camera, and reconfigure its IP address to 10.1.1.xx (xx ranges from 11 ~
253), in the same network segment as the recorder.
a) Move your mouse to the left to call the quick bar, and select “ ”. You’ll see the list of every connected IP
camera with its connection status to this recorder and MAC address.
b) Select the IP address which is not used, and select “SETUP”.
IP SEARCH
IP PORT MAC TYPE PROTOCOL STATUS
10.1.1.12 88 00:0e:53:e5:9a:f1 IP CAMERA AVTECH CONNECTED TO CH1
10.1.1.12 88 UNKNOWN IP CAMERA ONVIF CONNECTED TO CH1
10.1.1.13 88 00:0e:53:a6:91:18 IP CAMERA AVTECH CONNECTED TO CH2
10.1.1.13 88 UNKNOWN IP CAMERA ONVIF CONNECTED TO CH2
10.1.2.14 88 00:0e:53:a5:9f:a2 SWITCH AVTECH UNUSED
10.1.2.14 88 00:0e:53:a5:9f:a2 SWITCH AVTECH UNUSED
10.1.1.15 88 00:0e:53:e1:4e:k5 IP CAMERA AVTECH CONNECTED TO CH3
10.1.1.15 88 UNKNOWN IP CAMERA ONVIF CONNECTED TO CH3
10.1.1.16 88 00:0e:53:s5:3e:h6 IP CAMERA AVTECH CONNECTED TO CH4
10.1.1.16 88 UNKNOWN IP CAMERA ONVIF CONNECTED TO CH4
10.1.1.17 88 00:0e:53:e6:4b:26 IP CAMERA AVTECH CONNECTED TO CH5
10.1.1.17 88 UNKNOWN IP CAMERA ONVIF CONNECTED TO CH5
CONNECT SETUP EXIT
c) Select “DHCP” in “NETWORK TYPE”.
d) Click “APPLY” and “EXIT” to save your changes.
SETUP
NETWORK TYPE DHCP
IP 10.1.1.14
PORT 88
USER NAME admin
PASSWORD *****
NETMASK 255.0.0.0
GATEWAY 10.1.1.10
PRIMARY DNS 168.95.1.1
APPLY EXIT
e) The recorder will then detect the IP camera and display images soon.
To Next Page
Loading...
