Avtech AVH408P - Pse; Multicasting

MAIN MENU
37
5.4.9 PSE
Note: This function is available only for models with PoE or PoN function.
Users could check the power supply status in this menu, and disconnect power supply to the camera if needed.
ADVANCED CONFIG
CONNECTION
CH1 CH2 CH3 CH4
CAMERA
POWER SUPPLY AUTO
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
NOTIFY
PSE
MULTICASTING
VOLTAGE (V) CURRENT (i) MAX MIN AVERAGE STATUS
47.828 86mA 86mA 60mA 74mA
PD CLASS: CLASS 2(170mA)
WATT(mW): 3495 TOTAL WATT(mW): 3491
EXIT
5.4.10 MULTICASTING
Note: This function is available only for selected models.
In this menu, users could configure the multicast address and port used for each channel for data streaming.
Three streams for different usage could be configured per channel. These are used for different video data
requests from different clients.
ADVANCED CONFIG
CH1 CH2 CH3 CH4
CONNECTION
MULTICAST STREAM1 ADDRESS 239.0.0.1
CAMERA
MULTICAST STREAM1 PORT 9000
DETECTION
STREAM1 TIME TO LIVE(TTL) 15
ALERT
MULTICAST STREAM2 ADDRESS 239.0.0.2
NETWORK
MULTICAST STREAM2 PORT 9002
DISPLAY
STREAM2 TIME TO LIVE(TTL) 15
RECORD
MULTICAST STREAM3 ADDRESS 239.0.0.3
NOTIFY
MULTICAST STREAM3 PORT 9004
PSE
STREAM3 TIME TO LIVE(TTL) 15
MULTICASTING
TIMEOUT (SECS) 50
LIMIT RECORD STREAM TRANSFER
EXIT
1) MULTICAST STREAM ADDRESS
Configure the addresses used for the three streams per channel.
The address range for multicasting is from 224.0.0.0 to 239.255.255.255.
Note: The address for each stream per channel should be unique and can’t be the same as other
stream in the same channel or other channel.
2) MULTICAST STREAM PORT
Set the event recording function on / off.
Configure the ports used for the three streams per channel.
The port range is from 1 to 65535.
Note: The port for each stream per channel should be unique and can’t be the same as other stream in
the same channel or other channel.