QUICK OPERATION
21
6. QUICK OPERATION
6.1 Power Switch
Note: This function is available only for “SUPERVISOR”. To know more details, please refer to “5.4 User
Level Creation” at page 17.
To power off or reboot the NVR, you may:
Turn the power switch (
) directly on the NVR rear panel (refer to “1.2 Rear Panel” at page 1), or
Go to
, and select (power off) or (reboot).
6.2 Channel Selection
To display a specific channel in full screen and restore to the 6-cut view, you may:
Directly click the channel you want on the screen, and click it twice to restore to the 6-cut view (refer to “5.2
Channel Selection” at page 15), or
Go to , and select the channel you want to display in full screen from 1 ~ 6, and select to restore
to the 6-cut view.
To Next Page
Loading...
