HARDWARE OVERVIEW
1
1. HARDWARE OVERVIEW
1.1 Front Panel
HDD LAN WAN
LED indicators
The NVR is power-supplied.
WAN
The NVR is connected to Internet.
LAN
The NVR is connected to LAN.
HDD
Up to one hard disk is installed in the NVR and connected well.
1.2 Rear Panel
DC12V INAUDIO
OUT
MOUSEUSBWAN
INTERNET
LAN
SWITCH
HDMIeSATA
1) eSATA
This port is used to connect a storage device supporting eSATA interface; for instance, an external hard disk
or a disk array.
Note: Please purchase a disk array supporting Linux system to ensure you NVR work properly.
2) HDMI
This port is used to connect the monitor, which supports high definition video output interface.
Note: Direct connection to the monitor, which supports VGA or composite interface, is not supported.
Please prepare a converter in advance.
3) LAN
This port is used to connect your NVR to IP cameras locally.
4) WAN
This port is used to connect your NVR to Internet via a RJ45 network cable.
5) USB
Insert a compatible USB flash drive for video backup.
Note: For the compatible list of USB flash drives, please refer to “APPENDIX 2 COMPATIBLE USB FLASH
DRIVE LIST” at page 44.
6) MOUSE
Insert a mouse for function operation.
7) AUDIO OUT
Connect to a speaker.
8) DC12V IN
Connect the NVR to power with the regulated adapter.
To Next Page
Loading...
