CONNECTION
2
2. CONNECTION
2.1 Hard disk installation
This NVR supports both 2.5” and 3.5” hard disk drives based on your demands. Please follow the instructions below
to install a hard disk in the NVR.
To install a 3.5” hard disk
Step1: Turn the NVR bottom side facing you, and remove the four screws.
Step2: Turn the NVR rear panel facing you, and slightly push the case upward to remove it, as shown below.
Step3: With the PCB side facing down, connect your hard disk to the NVR as shown below.
Step4: To fix the hard disk, please fasten it to the bracket with the supplied screws.
Step5: Replace the upper cover back to the NVR.
Step6: Replace and fasten the screws loosened in Step1 to the NVR.
To Next Page
Loading...
