CONNECTION
3
To install a 2.5” hard disk
Step1: Please follow the first two steps of To install a 3.5” hard disk to remove the upper cover of the NVR.
Step2: With the PCB side facing down, connect your hard disk to the NVR as shown below.
Step3: Please fasten the supplied bracket to the NVR, and fix the hard disk to the bracket.
Step4: Replace the upper cover back to the NVR.
Step5: Replace and fasten the screws loosened in Step1 to the NVR.
Note: Before remote firmware update, please install a HDD into your NVR first to make sure the
firmware update works properly.
Note: It’s not recommended to use a green HDD with your NVR to make sure it works properly.
To Next Page
Loading...
