REMOTE OPERATION
22
In the “Record Setting” page, you can set the following items:
‧Record type
‧Hard disk overwriting
‧Pre- / post-alarm record time
‧Record time setting
‧Record path
If “Manual” is checked, click “ ” on the main control panel to start the manual recording immediately, and the
recordings will be saved in the specified location. The red text indication “REC” will be shown at the top left corner
of the image display view.
If “Motion” and / or “Alarm” are checked, the recording function will also be enabled at the remote side when any
event is triggered at the DVR side, and the recordings will be saved in the specified location.
Playback
To play a recording, click “ ” → “ ”, and select the “Record” tab or “Backup” tab. A list of all the recordings
will be shown by defaults, and you can also sort out the logs you want to speed up the search time.
To immediately play a recording, select a log from the list, and click “Play”, or double-click the selected log. Then,
the playback control panel will be shown at the bottom of the main control panel similar to the following.
To Next Page
Loading...
