HALO – FVP Frame - Assembly Manual V1.1
Designs, Images and Content Copyright © Aeroxcraft Ltd. 2012 – 2016
Page 7
Step 1 - Assemble Flight Components
Assemble and setup all the flight components at this stage. Cut wires to
length and solder in place. Make sure all the wiring is clear of the propellers.
Being neat and tidy at this stage will help ensure your success!
Mount the ESC, Flight Controller, etc
(1x) Main Plate
(4x) M2.5 x 20mm CSK
(4x) M2.5 Nuts
Plastic spacers as required
Make sure the screws and nuts do not cause any electrical short outs.
The arrow in the Main Plate is to point forwards. It helps to avoid confusion
later!
Mount the Motors
(16x) M2 x 3mm Socket screws
Make sure the screws do not damage the internal wire inside the
motors.
Do not overtighten the screws as it will damage the motor screw
threads.
Thread-lock will stop screws becoming loose and falling out when there
are vibrations. Excessive vibrations can occur if you damage a
propeller.
To Next Page
Loading...