AXC HALO - Step 2: Assemble the Upper Structure

HALO – FVP Frame - Assembly Manual V1.1
Designs, Images and Content Copyright © Aeroxcraft Ltd. 2012 – 2016
Page 8
Step 2 - Assemble the Upper Structure
(4x) Carbon Hoops
(4x) Spacer Blocks
(4x) Hoop Supports
(2x) Camera Supports
(12x) M2 x 4 Socket Cap Screws
(8x) M2 x 5mm CSK (Countersunk) Pozi Screws
Assemble the parts as per the diagram below.
Use M2 x 5mm CSK (Countersunk) Pozi Screws in the upper holes. This
allows the props to clear the screws if the props deform upwards at full
throttle.