Axeon S-150 - Page 4

To Next Page

To Previous Page

S – 150 Controller User Manual

MKTF – 429-A 4 08/16

Operating Hours ................................................................................................................. 18

Temperature ....................................................................................................................... 18

Warning Messages ............................................................................................................. 18

Tank Full Operation ............................................................................................................ 18

Tank Full Restart ................................................................................................................ 18

Tank Full Override .............................................................................................................. 19

Pressure Fault .................................................................................................................... 19

Auto Reset .......................................................................................................................... 19

Alarm Silence ..................................................................................................................... 19

Pretreat ............................................................................................................................... 19

Membrane Flush ................................................................................................................. 20

Flush Mode ......................................................................................................................... 21

High TDS / Conductivity Warning / Alarm ............................................................................ 21

Operating Hours Exceeded ................................................................................................. 21

I/O Expander ...................................................................................................................... 21

Auxiliary Output .................................................................................................................. 21

Tank Low ............................................................................................................................ 22

Boost Pump Output ............................................................................................................ 22

Divert Output ...................................................................................................................... 22

Alarm Output ...................................................................................................................... 22

ADJUSTMENTS

TDS / Conductivity Calibration ............................................................................................ 22

Display Adjustment ............................................................................................................. 22

TROUBLESHOOTING

System Inoperative ............................................................................................................. 23

Display Blank ...................................................................................................................... 23

Inlet Valve Will Not Operate ................................................................................................ 23

RO Pump Will Not Operate ................................................................................................. 23

Unit Not Flushing or Not Flushing Correctly ........................................................................ 23

No or Incorrect TDS / Conductivity Reading ........................................................................ 23