2018-10-05 | Technical improvements, changes in design, printing- and other errors expected. 19
3.4.1. Remux mode
If the the Network ID are set on auto, the device works in the Remux mode. In this mode, the IDs from the set
transponder and from the satellite are used and forwarded to the modulators with virtually no changes. The
TS ID1 to TS ID8/16 of the modulators, are also set on auto.
Note:
If the device is already set to CROSS MULTIPLEX MODE, set the Network ID to auto.
Click on SAVE CHANGES.
The device ist set back to REMUX MODE.
To Next Page
Loading...