2018-10-05 | Technical improvements, changes in design, printing- and other errors expected. 39
Read NIT
Under STEP 1: READ NIT (DVB-C) the devices in the network are displayed.
Select the devices from which the NIT is to be read out.
The device you are currently configuring (This device) is always selected.
Click on READ NIT.
The data of the devices are read in and listed under STEP 2: VERIFY NIT.
Note: If necessary, you must reset the NIT before importing (see „Reset the NIT“ on page 40).
NIT Check
Note: If the NIT is edited, the headend automatically switches to cross-multiplex mode.
Values that overlap are displayed in red. These errors must be cleaned up before uploading.
Notes:
∂ Different TS-IDs must always be assigned
∂ The ON-ID must be the same for all headends
Values that overlap
To Next Page
Loading...