EasyManuals Logo

Axis 2100 User Manual

Axis 2100
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
Other IP Setup Methods AXIS 2100 User’s Manual
56
Notes for Macintosh Users
The AXIS 2100 supports TCP/IP over Ethernet, or PPP Modem dial-up. You must use
TCP/IP on your Macintosh network, as there is no support for AppleTalk.
When using the AXIS 2100 on a Macintosh, please observe the following points:
The camera has a default IP address of 192.36.253.80.
Assign a temporary IP address in the same subnet (e.g. 192.36.253.81) to a Mac workstation
and then connect to the camera.
The desired IP address for the camera should be set using the Installation Wizard.
The correct IP address for the Macintosh workstation should also be reset.
Changing the IP address for a Macintosh is simple and there is no need to reboot.
Currently there are limitations in the ActiveX Support in Internet Explorer running on the
Macintosh. This results in problems when viewing live moving images. The recommended solution
for viewing Axis cameras on the Macintosh is to use Netscape.

Table of Contents

Other manuals for Axis 2100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axis 2100 and is the answer not in the manual?

Axis 2100 Specifications

General IconGeneral
BrandAxis
Model2100
CategorySecurity Camera
LanguageEnglish

Related product manuals