AXIS 211W - System Options
36
Resetting to the Factory Default Settings
To reset the camera to the original factory default settings, go to the System Options > Maintenance web page
(as described in
Maintenance, on page 34) or use the Control button on the rear of the camera (see the
illustration on page 6) as described below:
Using the Reset Button
To reset the camera to the factory default settings using the Reset Button:
1. Disconnect the power adapter, or the network cable if using PoE.
2. Press and hold the Control button while reconnecting power.
3. Keep the Control button pressed until the Status Indicator color changes to amber (which may take up
to 15 seconds).
4. Release the Control button.
5. When the Status Indicator changes to Green (which may take up to 1 minute), the process is complete
and the camera has been reset. The unit will now have the default IP address 192.168.0.90
To Next Page
Loading...
