Axis AX1401 User Manual

EN-6
AUDIO DSP CONTROLS (2)
Press the SEL button again (for more than 2 seconds) to activate Selecting mode for DSP:
2 sec.
SEL
BEEP
ON / 2nd / OFF
VOL
2 sec.
BEEP
SEL
SEL
FLAT / POP / ROCK / CLASSICALDSP
SEL
ADJ
VOL
2 sec.
BEEP
SEL
SEL
SEL
SEL
STEREO
SEL
LOCDISP
SEL
STEREO
SEL
LOCDISP
SEL
2 sec.
SEL
STEREO/MONO
VOL
STEREO
SEL
LOCDISP
SEL
2 sec.
SEL
DX/LOCAL
VOL
LOCDISP
SEL
2 sec.
SEL
DISP
STEREO
SEL
LOCDISP
SEL
SEL
ADJ
to set hourto set minute
/
VOL
VOL
VOL
4. PRESET STATIONS (1-6)
Six numbered preset buttons store and recall stations for each band.
Storing a station:
1. Select a band (if needed)
2. Select a station
3. Hold a preset button longer than one second. Preset station number appears in the display when station is
saved.
Recall a station:
1. Select band (if needed)
2. Press a preset button for less than one second to select stored station.
Note: This unit is equipped with built-in memory I.C. (Integrated Circuits) to save user settings such as tuner
preset stations and audio control settings. To cancel these settings, switch to Radio mode, press and hold
button “1” for 2 seconds (do not release button) followed by pressing MD button. Unit will automatically
restart after 5 seconds.
5. MODE / SUBWOOFER BUTTON (MD/SUB)
Press MD to select between: AUX/TUNER/CD-MP3/USB or MMC/SD modes.
SUBWOOFER: Press and hold this button to engage subwoofer output.
6. BAND SELECTOR / LOUDNESS BUTTON (BD/LD)
 Pushthisswitchtoselectthedesiredband,eitherAMorFM.
LOUDNESS: Press and hold the button to select LOUDNESS mode.
7. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN )
(A) RADIO MODE
 Whenpressedforlessthan1second,thesekeysoperateasSEEKTuningmode.
 Whenpressedlongerthan1second,theyoperateasMANUALtuningmode.
 Ifthekeysarenotpressedfor3seconds,theywillreturntoAutomaticmode.
(B) CD/MP3 PLAYER MODE
Whenpressedforlessthan1second,thesekeysoperateasTRACKUPorTRACKDOWNmode.
When pressed longer than 1 second ,theywilloperateasCUEorREVIEWmode.
8. AUTOMATICALLY STORE STATIONS (A/PS)
Select six strong stations and store them in current band.
1. Select a band (if needed)
2. Hold A/PS button for more than three seconds. The new stations replace stations already stored in that
band.
Preset Scan
Scan stations stored in current band
1. Select a band (if needed)
2. Hold A/PS formore than onesecond but lessthanthree seconds. Radiopauses for veseconds at each
station. Press A/PS again to stop scanning when desired station is reached.
9. ACTIVE MATRIX DISPLAY
The Active Matrix Display will display the current state of the unit.
10. OPEN PANEL RELEASE BUTTON ( )
Press button and the front panel will open.

Axis AX1401 Specifications

General

Brand	Axis
Model	AX1401
Category	Car Stereo System
Language	English