USER MANUAL
17
_____________________________________________________________________________________________________________________
18. Pieces counting (F..-PCS)
This function enables to count
identical pieces, e.g. turnbuckles or
buttons.
A measurement is performed in two
phases:
- first phase - single piece weight
calculation on the basis of defined
pieces amount (5, 10, 20, 50, 100,
200 or 500 pieces),
- second phase – pieces counting.
It is advised that single piece weight
is not less than one reading unit and
sample weight used in first phase is
bigger than 100 reading units.
To leave function press MENU key
and then with
→Τ←
key chose
F..-PCS and F..-0.
Notes:
1. Err-3 communicate signalises that
a sample was not put on the pan.
The same communicate appears
if single piece weight is less than
one reading unit (it is possible to
count pieces but measuring error
is bigger).
2. To chose previously used pieces
amount select “..” in first phase
(in case no value was chosen,
error communicate appears).
3. During pieces counting
→
T
←
key
function does not change.
4.In scales equipped with LCD
display, weighing unit is visible
and "
" sign is replaced with
"pcs".
To Next Page
Loading...
Need help?
General
