AXISM30NetworkCameraSeries
Howtorepainttheproduct
•Toensurereassemblyandfunctionalityoftheproduct,openingsforscrews,LEDindicators,ormicrophonesmust
bemaskedbeforepainting.
Pretreatmentofparts
Dependingonthepartmaterialandtypeofpaintappliedatfactory,differentpretreatmentsshouldbedoneforthenewpaintto
adhereaswellaspossible.Forallvariantsthough,propercleaningtoremoveoil,greaseanddustisstronglyrecommended.
Formoreinformationonthematerialsusedintheproduct,seeitsdatasheetatwww.axis.com
Powdercoatedparts-Usingnesandpaper,removetheoriginalpowdercoatingdowntothestainlesssteelsurfaceandcleanthe
partsbeforepainting,oruseaprimer.
Anodisedandchromatedparts-Useaprimer.
Uncoatedstainlesssteel-Nospecialpretreatmentisneeded,butmakesurethatthesurfaceiscleanbeforepainting.
Plastic-Useaprimer.
Repainting
1.Makesureallnecessarypreparationsofthecovertophavebeenmade,seePreparationsonpage3.
Note
Avoidgettingpaintonthemagnetsinsidethecovertop.
2.Applyathinandevenlayerofspraypaintaccordingtotheinstructionsofthepaintmanufacturer.
3.Letthepaintdry.
4.Togetabettercoverageandclearercolor,applyasecondlayerofspraypaint.
5.Whenthepaintisdry,reassembletheproduct.
Reassembly
1.Snapthedomeandthecovertoptogether.
2.Reattachthecovertoptothecameraunit.
4