ipConfigure ESM 5.1
LPR Setup and Field Installation Guide
4
AXIS RECOMMENDED SETTINGS FOR P1346 CAMERA
INITIAL CAMERA SETUP
The first time you login to the camera you will be asked to apply a CAPTURE MODE -
we require this to be 2 MP 1600x1200 (4:3). If you have to do a default or a restore of
the camera, you will need to change this as well.
Ensure that the camera is running LPR firmware version (P1346_5_05_beta39_lpr2.bin)
and that the Fujinon 8/80mm lens is attached.
After firmware is successfully uploaded perform the following setup steps…
At initial login to camera or under Basic Setup Video Stream set to the following:
1 Set the capture and display resolution to 2 MP 1600x1200 (4:3) resolution
2 Set Compression level to 1
3 Save these settings
To Next Page
Loading...
Need help?
General
