Specification
9
Code 508211
Model TS-250M Basic
Rating Hobby
Power 1.5kW 230V 1ph
Blade Dia/Bore 250mm/30mm
Blade Tilt 0° to 45°
Max Depth of Cut @ 45˚ 60mm
Max Depth of Cut @ 90˚ 80mm
Max Width of Cut with Fence 160mm standard, 760mm with R/H Table Kit
Table Size 635 x 430mm
Table Height 360mm
Dust Extraction Outlet 100mm
Min Extraction Airflow Required 750m³/hr
Overall L x W x H 660 x 480 x 400mm
Weight 80kg
Assembly
Locate and identify the four leg “A” frames (H), the
long struts (I) and the short struts (J) for the stand,
and the packet containing 32 M8 x 16mm coach
bolts, washers and nuts,(L1).
Using the M8 x 10mm coach bolts, nuts and
washers bolt together two ‘A’ frames using two
legs (H) one long strut (I) in the middle and one
short strut (J) at the top. ‘finger tighten’ the nuts
only at this time, see fig 1.
When the two ‘A’ frames have been assembled,
select one, turn it upside down on a flat surface
and loosely bolt the ‘short struts’ (J) and long struts
(I) in place, see fig 2. Attach the other “A’ frame
and loosely tighten.
When all the components are
assembled, turn the stand over
and place the four rubber
feet (K) to the ends of the ‘A’
frames. (See fig 3) Upright the
frame and stand on the floor,
see fig 4.
NOTE: GO ROUND THE
FRAME AND FINGER
TIGHTEN THE NUTS AT
THIS POINT!
Optional Stand Assembly (Kit Code 508213)
Fig 01
Fig 02
Fig 04
Fig 03
I
J
I
K
J
H
L1
To Next Page