H1
H2
H3
H4
H5
H6
Extending the
cutt
ing line
WARNING: Do not use any kind of metal wire or metal wire encased in plastic in the
cutting head. This may cause serious injuries to the user.
Your machine
is equipped with tap automatics with double string. it means that
both strings will be extended when the cutting head touches the ground and the
machines runs on full grass.
1.
Hold the ma
chine in operation over the grass area and slightly touch the
ground with cutting head several times. In this way you extend the string
2.
The knife in the protection guard cuts the string to required length.
1.
Hold the machi
ne in operation over the grass area and slightly touch the
ground with cutting head several times. In this way you extend the string
2.
The knif
e in the protection guard cuts the string to required length.
St
o
pping the
engi
ne
1.
Reduce the engine speed and let it run with no load for a few minutes.
2. Switch off the engine by moving the engine switch to the stop position.
The accessory may cause an accident if it continues to turn after the engine has
stopped or after the engine switch has been released. When the unit has stopped,
check carefully that the accessory has stopped turning before putting the unit down.
100 101
GB
MAINTENANCE
G
o
od maintenance is essential for safe, economical and trouble-free operation. It will
also help reduce air pollution.
The purpose of the maintenance and adjustment schedule is to keep the
machine in the best operating condition.
Turn off the engine before performing any maintenance. If the engine must be run,
make sure the area is well ventilated. The exhaust contains poisonous carbon
monoxide gas
Please always select recommended accessories. The accessories which have not
equivalent quality may damage the machine.
Please never use non approved components and remove the safety devices
after or during maintenance.
Ma
i
n
tenan
c
e
Dail
y
maintenan
ce
W
eek
l
y
mainte
nance
Mon
t
hl
y
maintenanc
e
Clea
n the outside of the machine. X
Ma
ke sure the throttle trigger lock and the
thr
ottle function correctly from a safety
poi
n
t of view.
X
Chec
k that the engine switch
orks
cor
ectl
.
X
Chec
k that the blades do not move when the
engine is i
dling or when the choke is in the
sta
rt throttle position.
X
Check
that
the blades are undamaged and
show no signs of cracking or other damage.
Replace the blades if necessary.
X
Chec
k that the blade guard is not damaged
or distorted. R
eplace the blade guard if it is
bent
or damaged.
X
Cl
ean the air filter. Replace if necessary. X
Chec
k that nuts and screws are tight.
X
To Next Page
Loading...