13
AB-7329
z Installation position
• This product should be installed upright in the panel.
Installation of this product on a slant or laid on its
side is prohibited. Doing so reduces heat radiation
performance, which may cause the internal tempera-
ture to rise abnormally.
Vertical direction
Front view Side view
Figure 8. Installation position
• Do not block the ventilation holes by putting an
object, etc. on the top of the product.
z Installation method
<Installation on DIN Rail>
(1) Pull down the DIN holder (x 1) on the bottom of the
device.
Pull down
(2) Hook the upper part of the DIN holder to the DIN rail
and check that it is hooked securely.
Hook on the DIN rail
(3) Push up the DIN holder (x 1) on the bottom of the
device.
Push up
(4) Check that the two DIN holders on the top and
bottom of the device are secured on the DIN rail.
Check that the device is steady.
(5) Secure both ends with the DIN rail clamps (Model
83104567-001).
After installation, keep the connectors that come
with the device because they will be used for wiring
connection.
<Direct Installation with Screws>
Install the product on the wall using two M4 L=8 screws.
(1) Make two screw holes on the place for installation.
154 mm
(2) Push up the DIN holder on the top of the device and
then pull out the DIN holder on the bottom.
Pull down
Push up
(3) Use the two holes for the DIN holder to secure the
device with the M4 L=8 screws.
Check that the device is steady.
After installation, keep the connectors that come
with the device because they will be used for wiring
connection.
To Next Page
Loading...
