Azden 35HT - Page 3

3
Operang the System
WARNING
・Do not use other baeries than the ones specied in this manual. Do not mix a fresh
baery with a used baery.
・When installing baeries, make sure baery polarity is correct as marked inside the
baery compartment.
・Remove the baeries if the products are not used for a long period of me.
・Do not submerge the products.
Because this is a frequency agile system, the receiver and transmier must be on the same
channel number. To change the channel selecon, use a small , sharp object such as the p of
a pen, and press the “UP” or “DOWN” buon to the desired channel. Make sure both the re-
ceiver and transmier are on the same channel.
310UDR Diversity Receiver
Aer installing new baeries, mount the receiver to your video camera with supplied
shoe mount or hook & loop fastener. Select one of the supplied cables and connect the
output on the receiver and input on the video camera. Turn the power switch to “ON”
and the baery level indicator on the LCD display should come on. If not, check the
baeries. When the 310UDR receives a signal from the transmier, the recepon level
indicator will come on. If it does not, make sure both the receiver and the transmier
are on matching channels.
35BT Body-Pack Transmier
Plug in the supplied EX-503L Lavalier Microphone and clip it to your subject. The micro-
phones should be placed 4”-12” from the subject’s mouth. Clip the transmier to a
belt by using the supplied belt clip or place it in a pocket. Turn the power switch to
“ON” and the baery level indicator on the LCD display should come on. If not, check
the baery. Have someone speak into the microphone as you monitor the sound
through the 310UDR Receiver’s phone output. If the sound is distorted, lower the MIC
input level on the 35BT Transmier. If there is not enough volume, raise the MIC input
level on the Transmier.
35XT Plug-in Transmier
Aach the 35XT Transmier to any low impedance microphone with a corresponding 3-
pin XLR connector. Turn the power switch on the 35XT Transmier to “ON” posion
and the baery level indicator on the LCD display should come on. Have someone
speak into the microphone as you monitor the sound through the camera’s monitor
output. If the sound is distorted, lower the MIC input level control on the 35XT Trans-
mier. If there is not enough volume, raise the level control on the Transmier.