EDGEWINDER OWNER’S MANUAL PAGE 11
05-2017
STARTING THE ENGINE
Understand the operation of all controls and learn how to stop the engine quickly in case of
emergency.
Although this HONDA engine is equipped with a
catalytic muffler for safety, its exhaust still contains small amounts of
poisonous carbon monoxide. Do not run the engine without adequate
ventilation.
The engine and exhaust become very hot during operation. Keep the engine
at least 1 meter (3 feet) away from buildings and other equipment. Keep flammable materials away,
and do not place anything on the engine while it is running.
Make sure the operator receives adequate instruction before operating the
equipment.
Do not allow children to operate the machine. Keep children and pets away from
the area of operation.
1.) Once the BEFORE OPERATION CHECKLIST on pgs 9-10 is completed, adjust the machine
handle to comfortable position using pin to secure in place.
2.) Open the LPG tank valve by turning counter clockwise.
3.) Set the throttle control switch to the SLOW position.
4.) Push the “START” button until engine starts. Starter should not be engaged for more than 10
seconds at a time. If hard starting is a problem, carefully review BEFORE OPERATION
CHECKLIST on pgs 9-10. As soon as the engine starts, immediately move throttle cable into
desired engine speed.
5.) Begin operation of machine.
STOPPING THE ENGINE
Always remove ` from switch when leaving engine will be unattended or when
engine is not in use.
To stop the engine in an emergency, simply move the control lever to the OFF position. Under normal
conditions, use the following procedure:
Move the control lever to the OFF position. The control lever shown to the right is connected to a
throttle cable.
1.) Turn the key switch to the OFF position.
2.) Turn the propane valve lever to the OFF position by turning the valve clockwise.
To Next Page
Loading...