EDGEWINDER OWNER’S MANUAL PAGE 12
05-2017
CONTROL LEVER
The control lever operates the engine switch and throttle.
OFF --------- Stop the machine by switching off the ignition
system. All other control lever positions leave
the ignition system switched ON.
MIN. --------- For running the engine at idle speed.
MAX. -------- For restarting a warm engine, and for running
the engine at maximum speed.
The control lever shown here will be connected to a throttle cable.
SETTING ENGINE SPEED
Position the throttle cable to the desired engine speed.
OPERATION
This propane edging machine is designed to strip and scrub edges along walls and shelving kick
plates, and to reach under racks, gondolas, and shelving, to dig out years of accumulated dirt and
grime. Easily cuts through layers of edge build up. No other application of this equipment should be
attempted nor is recommended. Call Aztec (800) 331-1423 for any additional application questions.
First, refer to the SAFETY INFORMATION on pgs 3-8, and complete the BEFORE OPERATION
CHECKLIST on pgs 9-10.
Never tilt back machine while engine is running. Objects may fly out from
underside of machine and damage can occur to the machine, furniture, buildings and/or personal
injury.
Provide and use ear protection during operation.
All machines are equipped with tamper proof fuel systems. If a fuel problem
exists, contact an authorized service center.
All machines are equipped with a multi-function maintenance meter. The
functions include the following: hours, service alert and tachometer; see ENGINE MAINTENANCE
METER instructions on pg 22.
To Next Page
Loading...