Aztec EDGEWINDER - OIL FILTER CHANGE PROCEDURE; OIL FILTER REPLACEMENT STEPS AND CAUTIONS

To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
EDGEWINDER OWNER’S MANUAL PAGE 19
05-2017
OIL FILTER CHANGE (IF EQUIPPED)
Change the oil filter every 100 hours of operation.
Before removing the oil filter, place a suitable pan under filter connection.
1.) Drain engine oil into a suitable container.
2.) Rotate the oil filter (A) counterclockwise to remove it.
3.) Coat a film of clean engine oil on seal of new filter.
4.) Install new filter rotating it clockwise until seal contacts mounting surface (B). Then rotate
filter 3/4 turn more by hand.
5.) Supply engine oil as specified.
6.) Run the engine for about 3 minutes, stop engine, and check oil leakage around the filter.
7.) Add oil to compensate for oil level drop due to oil filter capacity (See OIL LEVEL CHECK on
pg 17).