Aztec EDGEWINDER - EMISSION SYSTEM TAMPERING AND SPECIFICATIONS; TAMPERING, EMISSION PROBLEMS, AND QUICK REFERENCE

To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
EDGEWINDER OWNER’S MANUAL PAGE 28
05-2017
Tampering and Altering
Tampering with or altering the emission control system may increase emissions beyond the legal
limit. Among those acts that constitute tampering are:
• Removal or alteration of any part of the intake, fuel, or exhaust systems.
• Altering or defeating the governor linkage or speed-adjusting mechanism to cause the engine
to operate outside its design parameters.
Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine inspected and repaired by an
authorized servicing dealer:
• Hard starting or stalling after starting.
• Rough idle.
• Misfiring or backfiring under load.
• Afterburning (backfiring).
• Black exhaust smoke or high fuel consumption.
Maintenance
Follow the MAINTENANCE SCHEDULE on pg 23. Remember that this schedule is based on the
assumption that your machine will be used for its designed purpose. Sustained high-load or high-
temperature operation, or use in unusually wet or dusty conditions, will require more frequent
service.
Specifications
ITEM
SPECIFICATION
MAINTENANCE
Spark plug gap
0.70-0.80 mm
(0.028-0.031 in)
Refer to pg 21
Idle speed
1,400 +/- 150 rpm
See your authorized HONDA
dealer
Valve clearance (cold)
IN: 0.15 +/- 0.02 mm
EX: 0.20 +/- 0.02 mm
See your authorized HONDA
dealer
Other specifications
No other adjustments needed.
Quick Reference Information
Engine Oil
SAE 10W-30, API SF or SL, for general use.
Refer to pg 17
Spark Plug
BPR5ES (NGK)
Maintenance
Before each use:
• Check engine oil level. Refer to pg 17
• Check air filter. Refer to pg 20
First 20 hours:
• Change engine oil. Refer to pg 18
Subsequent:
Refer to the MAINTENANCE SCHEDULE on
pg 22-23.