EasyManua.ls Logo

Aztec EDGEWINDER - OPERATIONAL SAFETY WARNINGS AND CAUTIONS; VENTILATION AND EXHAUST HAZARDS; OPERATOR AND EQUIPMENT SAFETY

Default Icon
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
EDGEWINDER OWNER’S MANUAL PAGE 5
05-2017
Operate only in well ventilated areas. Buildings must be provided with:
A. A continuous mechanical ventilation that removes the products of combustion to the outdoors of not less than 300
CFM for each 10,000 BTUH or fraction thereof; or
B. Natural ventilation of not less than 300 CFM for each 10,000 BTUH input or fraction thereof, based on a maximum
of one-quarter air exchange per hour for the net building volume.
Although this machinery utilizes a catalytic muffler to treat and minimize all engine emissions,
the exhaust may still contain trace amounts of carbon monoxide gas and chemicals known in the state of California to cause
cancer, birth defects or other reproductive harm.
Never let an untrained or irresponsible person operate the machine. They may hurt themselves
and/or damage the floor or other property.
Always check oil before attempting to start engine. Low oil may result in serious and expensive
engine damage.
Never complete the connection of the propane tank to the machine by using a tool; always tighten
and loosen by hand. Use of tools to tighten or loosen tank connection may result in damage to tank valve and insecure
connection. Listen for the rush of fuel to the lock-out device when you open the tank valve. If you hear this, it will indicate
that a good connection has been made at the tank.
Muffler is HOT. Keep all heat sensitive objects away from the exhaust system during and after
operation. Damage can occur to the machine, furniture, buildings and/or personal injury.
Do not leave this machine unattended while the engine is running. Damage to floor surface or
other property may occur and fumes may accumulate.
Keep machine moving to avoid floor damage. Do not operate machine in a stationery spot for
more than a few seconds. Machine is designed to be moved continuously forward at a measured pace. Stationary operation
will result in damage to floor surface.
When the LPG tank is attached to the machine and not running, the tank valve must be in closed
position.
Using the electric starter for more than 5 seconds at a time will overheat the starter motor and can
damage it.

Related product manuals